HP — Recovering from loss of extrusion

Recovering from loss of extrusion NOTE: It is recommended that you read and understand this entire procedure before performing any of the work. 1. Enter Head Maintenance mode. A. From Idle , press Maintenance . B. Press Machine . C. Press Head. The head will heat up to operating temperature which will take approximately 3 minutes. GLOVES: The head area is hot. Use gloves when working in this area of printer. 2. Remove the head cover by pressing the tabs in and pulling away from the head. See Figure 56. 3. Place the toggle bar in neutral position (bar will extend equally from both sides of head). This can be done manually - push on the extended bar end. See Figure 60. Figure 59:

Head Components Support side idler wheel Toggle spring Model side idler wheel Heater shield Drive wheel Toggle bar -82