Figure 60: Toggle bar in neutral position 4. Remove any excess material found around the head area. NOTE: Material fed to the tip can sometimes jam causing a build- up of material under the head cover. A. Clean out as much of the material as possible using needle nose pliers, a probe, or equivalent tool. CAUTION: The end of the tip where the material enters is called the extrusion tube. Extrusion tubes are fragile. Use care when working in this area so as to avoid damage to the tubes. B. For easier access to areas that may need to be cleaned, move the material idler wheels out of the way (there is one idler wheel for support material and one for model material , see Figure 59. NOTE:
Move only one idler wheel assembly at a time. Finish cleaning around the moved wheel and restore it to its normal position before moving the other idler wheel. Having both wheels out of position simultaneously could stretch the spring. i. Place a 7/64 T-Handle Allen wrench between the toggle spring post and the idler wheel post as illustrated in Figure 61. (model side shown). -83