Chapter 7: Maintenance NOTE: Refer to Robot Installation on page 21 for details on installing the outer arms. Removal is the reverse of installation. 1. Remove the three pairs of outer arms from the three pairs of ball studs on the installed platform. 2. For a J4 platform, disconnect the theta drive shaft from the platform drive shaft. See Theta Drive Shaft on page 107 for details. Do not remove the top U-joint, which is attached to the J4 motor shaft. 3. Attach one pair of outer arms to each of the three pairs of ball studs on the new plat- form. l The platform is installed flange-down. l Take care not to trap debris between the ball studs and their sockets. 4.
For a J4 platform, attach the theta drive shaft to the platform drive shaft. See Installing a Drive Shaft on page 110 for details. 7.13 Replacing a Ball Joint Insert 1. Remove the old insert. The inserts have a threaded hole in the bottom to facilitate removal. Use an M4 bolt to thread into the insert, and pull it out. 2. Install the new insert. Ensure that the insert is centered in the ball joint socket, and bottomed-out. 7.14 Replacing Outer Arm Spring Assemblies NOTE: It is unlikely that you will ever need to remove the components of the outer arm spring assemblies. Removing Outer Arm Springs 1. Bend the spring so that the end is 90° from normal. See the following figure.
Hornet 565 Robot User's Guide, 14608-000 Rev C Page 117 of 156