omron — 7.14 Replacing Outer Arm Spring Assemblies

Chapter 7: Maintenance The narrowest part of the horseshoe is 90° from the groove in which the spring end normally rests. 3. Repeat these steps for the remaining spring. Removing Outer Arm Spring Horseshoes NOTE: The only reason for removing an outer arm horseshoe is to replace one that has been damaged. 1. Remove the outer arm springs from the horseshoe. See the previous section, Removing Outer Arm Springs on page 117. 2. Cut the horseshoe with diagonal cutters. Take care not to damage any part of the outer arm end. 3. Remove the cut horseshoe from the outer arm pins. Installing Horseshoes 1. Slip one end of the horseshoe over one of the outer arm pins. See the following figure.

Figure 7-13. Horseshoe over One Pin 2. Pull the loose end of the horseshoe (spreading it slightly), and slip the end on top of the other outer arm pin. The horseshoes are very stiff, and do not bend easily. See the following figure. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 119 of 156