Chapter 7: Maintenance Figure 7-14. End of Horseshoe on Pin 3. Squeeze the horseshoe the rest of the way, until it is over the pin. See the following fig- ure. The horseshoe will snap into place. Figure 7-15. Squeezing the Horseshoe into Position Installing Springs on a Horseshoe 1. Slip the spring onto the horseshoe at 90° from its normal position. Refer to the figures in Removing Outer Arm Springs on page 117. The narrowest part of the horseshoe is 90° from the groove in which the spring end nor- mally rests. 2. Repeat for the remaining spring. Installing the last spring is the most difficult, as the other spring will tend to keep the spring from moving.
Hornet 565 Robot User's Guide, 14608-000 Rev C Page 120 of 156