omron — Removing the eAIB Chassis

Chapter 7: Maintenance Hornet 565 Robot User's Guide, 14608-000 Rev C Page 122 of 156 8. Using a 5 mm hex wrench, carefully unscrew the chassis securing screw, which is shown in the following figure. Note that the screw does not need to be completely removed in order to remove the chassis, as this screw is captured on the chassis heat sink. Figure 7-17. Securing Screw on eAIB Chassis 9. Carefully and slowly lift up the chassis (see the following figure), so that enough access is available to remove the internal cables. The chassis can be laid flat on its cooling fins. CAUTION: The eAIB can damage the O-ring that seals it if you are not careful. Ensure that nothing scrapes against the O-ring.