omron — Safety Commissioning Utilities

Chapter 7: Maintenance l Teach Restrict Configuration This sets the hardware Teach Restrict maximum speed to factory specifications. l Teach Restrict Verification This verifies that the hardware Teach Restrict is functioning correctly. The initial utility screen will tell you which functions are commissioned. If a function is not commissioned, its verification wizard will not be displayed. Any displayed verification wizard can be run at any time, to ensure that its function is working properly. Prerequisites l The robot must be set up and functional. l ACE software must be installed. l If using a factory-supplied Front Panel, the keyswitch must be in Auto mode. Figure 7-20.

Front Panel l No E-Stops can be activated. l For Configuration (E-Stop and Teach Restrict), the eAIB Commissioning Jumper must be plugged into the XBELTIO jack on the eAIB. NOTE : This is the only time that this jumper will be used. It is part number 11901-000, and must be removed for Verification and normal operation. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 126 of 156