omron — Payload Inertia vs. Acceleration

Chapter 8: Technical Specifications Payload Mass vs. Acceleration To avoid excited vibrations, the following acceleration values are recommended for given tool payloads. Table 8-2. Payload Mass vs. Acceleration - Hornet 565, Both Platforms Payload Inertia vs. Acceleration The following table provides a general guideline based on typical high-performance use. The practical inertia for any application will vary depending on the performance requirements. Table 8-3. Payload Inertia vs. Acceleration NOTE: The fixed platform is not covered in this table because it does not rotate.

Pay- loads for the J4 platform should be designed with their center-of-mass in line with the center axis of the tool flange. This will minimize induced torque during XYZ motions. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 143 of 156 Platform Type Payload Maximum Acceleration Preferred Acceleration kg %a m/s2 g %a m/s2 g Fixed 8.0 110 22 2.2 55 11 1.1 Fixed 7.0 130 25 2.6 65 13 1.3 Fixed 6.0 170 33 3.4 85 17 1.7 Fixed 5.0 220 43 4.4 110 22 2.2 Fixed 4.0 270 53 5.4 135 26 2.7 All 3.0 400 78 8.0 200 39 4.0 All 2.0 450 88 9.0 225 44 4.5 All 1.0 500 98 10.0 250 49 5.0 All 0.1 550 108 11.0 275 54 5.5 a% is the eV+ Accel/Decel setting, which, for the Hornet 565, can be set as high as 750%.

Acceleration Value Allowable Tool Inertia (kg-cm2) 100 600 250 240 500 120 750 80