Reconfiguring Your Plotter To See the Current Overall Configuration of the Plotter To See the Current Overall Configuration of the Plotter Utilities Statistics Full menu mode only 750C Plus 7-2 Item Comments Max X Max Y These two figures, in millimeters, give the size of the current plotting area, that is, the area in which the plotter will print the next plot unless it is changed. Normally each plot file received sets these dimensions with its Page Size command. You can impact it by: the current front-panel setting for Page format / Size. the media size currently loaded. Remember: Plotting area = page size minus margins. X represents the vertical (paper path) axis.
Y represents the horizontal (carriage path) axis. Code rev This is the revision number of the plotter’s internal code. RAM present This is the size, in megabytes, of the plotter’s main standard memory, plus the amount of memory reserved for printing. This does not correspond directly to the size of your files on the computer, as explained on page 7-10. This is the total RAM, not the RAM currently free. Media This is the media type which the plotter thinks is currently loaded (or was last loaded), on the basis of what you specified when you loaded it. For an explanation of media types, see page 3-3. In this display, the following abbreviations are used: Translucent = Translucent bond.
High-gl photo = High-gloss photo paper. Semi-gl photo = Semi-gloss photo paper. High-gl film = High-gloss film. Nat. tracing = Natural tracing paper. ROM SIMM This tells you if an optional ROM SIMM is installed in the plotter, for example PostScript.