Front-Panel Messages Front-Panel Messages This is a list of all possible messages in the front-panel display. If you need to do something, it is shown in italics in the Explanation and Action column. The messages are listed in alphabetical order. Message Explanation and Action Alignment error Continue The alignment procedure has failed. Check that an opaque media is loaded. Press ↓ to continue and force the automatic alignment procedure again by reseating any of the print cartridges. Do not lift the window while cartridge alignment is being performed. Calibrate error Continue The calibration plot was loaded incorrectly and it could not be measured.
Press ↓ to continue, then reload the plot for measurement. Follow front panel instructions. Calibration done Continue Accuracy calibration is complete. Press ↓ to continue. Close roll cover Continue Rewind the media to take up any slack in the roll, close the roll cover, then press ↓ to continue. Create pattern Measure pattern Press ↑ to create the pattern for automatic calibration. Press ↓ to start the automatic calibration. Edge not found Reload media The plotter could not find edge of media during loading procedure. Check the leading edge of the media for unevenness or tears; cut a straight edge, if necessary, and reload.
Be sure to position the right edge along the perforated line on the entry platen when loading. Lift lever Lift the lever at the right of the plotter. Load arrow edge print side down Remove calibration plot, turn it so that the edge with arrows printed on it is print side down, then load that edge into the plotter. Load cancelled Remove media You pressed the Cancel button while media loading was in progress. Remove media. Load error Remove media You inserted media with the media lever raised. Lower the lever and reload the media. Load media to align cartridges Load media to proceed with cartridge alignment.
Lower lever after aligning When you have finished aligning the roll media as instructed, lower the lever at the right of the plotter. 10-2