HP — HP DESIGNJET 700/750C PLUS PLOTTER - USER'S GUIDE, C4705-60021

Front-Panel Messages Message Explanation and Action Lower lever to continue You lifted the media lever while the processor was busy. Lower the lever to continue. Lower window to continue You opened the window while the processor was busy. Close the window to continue. Media too small The media you loaded for accuracy calibration or cartridge alignment is too small. Reload appropriate media. See page 7-5. Mispositioned Reload roll The roll is mispositioned. Reload media. Mispositioned Reload sheet The sheet is mispositioned. Remove it and reload it with the right edge no more than 0.2 inches (0.5 cm) from either side of the perforated line on the entry platen.

MIO data error The modular interface is incorrectly configured. Press Enter to clear the message from the front panel display. Recheck the MIO configuration settings. MESSAGES 10 MIO error Communication Break The flow of data from the computer to the plotter was prematurely stopped (e.g., by turning off the computer before all data is sent). Press Enter to clear the message from the front panel display. Open window to access cartridge(s) Lift the window to access the cartridge(s). Out of memory Data was lost The current plot is too large for the plotter’s buffer. Install additional memory to plot this drawing.

Pull  / Align  edges to roll Grasp the left and right free edges of the roll media and pull toward you until the media is taut. At the same time, align the left and right edges of the media so that they are flush with the left and right edges of the roll. Remove media The ink is dry. Remove the calibration plot the plotter just produced. Press ↓ to continue with accuracy calibration. Remove media Lower lever You have attempted to load media while the lever at the right of the plotter was raised. Remove the media, lower the lever, and reload media with the lever down. Replace cartridge(s)   The cartridge indicated has a clogged nozzle. Replace it to continue.

Reseat cartridge(s)   The cartridge indicated is badly seated. Reseat it to continue. Roll misaligned Reload roll Roll media is misaligned (skewed). Reload media. RS-232 error Baud, parity The RS-232-C interface is configured incorrectly. Press Enter to clear the message from the front panel display. Check the baud rate and parity settings in the front panel, in the hardware configuration, and in your software to be sure they are all compatible. 10-3