Setting Up the Plotter Task 1: Check That You Have All the Items Required Task 1: Check That You Have All the Items Required Supplied 1 You need the following items, which were supplied with the plotter. Power cord The power cord supplied with your plotter should meet the plug requirements for your area. However, different power cords (international options) are available. If necessary, contact your dealer or HP Sales and Support Office. SETUP 1 A roll of HP Opaque Bond Paper (for the HP DesignJet 700) Print cartridge(s): A roll of HP Coated Paper (for the HP DesignJet 750C Plus) 700 For the HP DesignJet 700: – Two black For the HP DesignJet 750C Plus:
– One yellow – One cyan – One magenta – Two black 750C Plus 2 Inspect the plotter itself and the above accessories. If you received any item in a damaged condition, notify the dealer or HP Sales and Support Office where you purchased the plotter, and file a claim with the carrier. Not supplied 3 You will also need the following items, which were not supplied with the plotter. For details of suitable cables, see page 11-8. Interface cable Optional 4 If you have purchased extra memory, you will need your Memory expansion module For details of the memory expansion modules available, see page 11-14. 1-5