Setting Up the Plotter Task 4: Load Media Task 4: Load Media For advice on the availability and use of different media types, see the section starting on page 3-2. IMPORTANT Because the next task is to load the cartridge(s) and carry out the automatic cartridge alignment procedure, you must load opaque media at this stage – for example, opaque bond (plotter paper) for the DesignJet 700 or coated paper for the DesignJet 750C Plus, as this necessary for the alignment procedure. A roll of suitable HP Media is supplied with your plotter. SETUP 1 To load roll media, start with step 1 below. To load sheet media, go to page 1-18.
To Load a Roll 1 Make sure the plotter wheels are locked (the brake levers pressed down) to prevent the plotter from moving. 2 Open the roll cover and remove the empty spindle by pulling firmly on each end. The two ends are different: end A has a media stop and end B a smaller end cap, as shown on the next page. B Roll cover A Place the spindle vertically on the floor, with the media stop at the bottom, ready for the new roll. 1865 1-11