4-5. Use other driving system Caution Be sure to prevent the rear bumper from being clashed when parking. Otherwise, the sensor in the bumper may be displaced or damaged, and thus cause the SWA to be automatically shut down or the SWA function to be affected. To ensure the normal operation of the system, the sensors in the bumper must be kept clean, free of ice and snow, and must not be covered by other articles. The rear bumper is only allowed to be sprayed with the paint approved by our company. Failure to do so may result in limited functionality of the SWA or a trouble in the SWA. If blind area detection does not work normally, the system should be shut down immediately.
Contact an authorized Hong Qi dealer of China FAW for maintenance. After the blind area detection system is repaired, calibration is required. For details, please contact an authorized Hong Qi dealer of China FAW. The blind are detection system will not give an alarm for pedestrians, animals, bicycles and other targets in the blind area. Blind area detection system only serves as an auxiliary reminder and cannot completely avoid collision of vehicles in blind areas. Before changing lanes, be sure to check the rearview mirror, sweep backward and use the turn signal.
Under special working conditions, such as humid weather and excessively high vehicle speed, the blind area detection system may give false alarm or omission, which is a normal phenomenon. When the blind area detection radar behind the vehicle is blocked, the system will not work and the radar needs to be cleaned in time. Blind area detection system is limited by physical laws and system conditions, and may not be able to identify traffic conditions correctly under certain driving conditions. Such as the following conditions: ● On a lane with sharp turn. ● On carriageways of different width. ● On a fluctuated road in mountainous area. ● In bad weather.
● At some special structures on the roadside, such as high or offset highway guardrails. 192