Hongqi — 空白页面

4-5. Use other driving system CAUTIONS ■ Pay special attention to the people animals, and various obstacles around the vehicle. The sensors have undetectable blind spots. ■ When looking for a parking space or during parking, make sure that there are no obstacles in the parking space, such as stones, thin pillars or drawbars, because the system may be not able to detect such obstacles. ■ The system may not be able to recognize the surface or structure of certain objects (such as barbed wire, fences, snowdrifts, etc.) Therefore, check whether there is enough space in the parking space displayed before parking your vehicle. ■ The parking radar system detects an obstacle.

The car approaching the obstacle may disappear within the detection range of the sensor (this is very easy to happen when detecting obstacles that are too high or too low). As a result, these objects cannot be detected. Do not ignore the warning from the parking distance alarm system, otherwise, the vehicle may have the risk of collision. ■ Due to the influence of various external sound fields and electromagnetic fields (e.g. other vehicles using ultrasonic ranging, air pressure, engine noise, electronically controlled gears, induction coils, etc.), the system cannot achieve absolute anti-interference.

■ The anti-interference ability and detection performance of ultrasonic ranging may be reduced due to environmental conditions and obstacle reflection characteristics. This is determined by the physical strength of ultrasonic propagation. ■ The installation position of the sensor has an important influence on the system performance. It is reflected in the reflection of the bumper surface itself, ground echo reflection and detection range. ■ Avoid using high pressure cleaner or steam cleaner to clean the sensors, so as not to damage the sensors. Adopt small water stream to wash the sensor surface for a short time during vehicle cleaning, and maintain a distance over 10 cm.

■ The sound waves transmitting in the air is refracted and diffracted based on the physical properties. The difference in temperature in the air is one of the most important factors in the generation of non-uniform propagation media, thereby leading to acoustic diffraction. ■ The detection performance of ultrasonic detection equipment will be affected by the following factors: ● Hot exhaust gas. ● High-temperature asphalt pavement. ● Summer breeze. ● Temperature stratification.

■ When there is a difference between the bumper temperature and the ambient air temperature (which usually occurs in winter), temperature stratification will occur, resulting in sound wave diffraction and reflection echo under a specific bumper structure, thus posing a false alarm risk. ■ Some important factors that can lead to a reduced detection range or no detection: ● The bumper surface is covered with snow or sludge. ● The sensor surface is covered with lime mud or ice. ● High acoustic attenuation (for example, in a dry and hot environment). ● In heavy rain or foam. ● Obstructions with absorbing materials.

● When the edges and corners of flat obstacles are facing the sensor, the reflected echo only occurs within a specific angle range. 4 Driving 205