HP — Output rollers

Face-up roller 1 Turn the fuser assembly over. 2 Remove the gear (callout 1) from the face-up roller and release the tab (callout 2) on the face-up roller bushing. 3 Rotate the face-up roller bushing forward until the pin releases. 4 Slide the face-up roller away from the gear side, and lift it out of the fuser assembly. 2 1 Figure 51. Removing the output rollers (2 of 2) Reinstall note Flex the face-up roller bushing to pop the pin back into place. 108 Chapter 5 - Removal and replacement ENWW