HP — E-label assembly (hp LaserJet 1300 only)

E-label assembly (hp LaserJet 1300 only) 1 Remove the left side cover (see “Left side cover” on page 81). 2 Remove the back cover (see “Back cover” on page 82). 3 Remove the right side cover (see “Right side cover” on page 84). 4 Remove the top cover (see “Top cover” on page 87). 5 Remove the fuser assembly (see “Fuser assembly” on page 103). 6 Open the print cartridge door. 7 Reach under the laser/scanner plate, and grasp the e-label assembly (callout 1), which is attached to the bottom of the laser/ scanner plate. 8 Unhook the two tabs (callout 2) to release the e-label assembly. 9 Pull down on the white e-label link arm (callout 3), and unhook the e-label assembly.

Remove the e-label assembly. 2 3 1 Figure 52. Removing the e-label assembly ENWW Internal assemblies 109