Motor 1 Remove the left side cover (see “Left side cover” on page 81). 2 Remove the back cover (see “Back cover” on page 82). 3 Remove the right side cover (see “Right side cover” on page 84). 4 Remove the fuser assembly (see “Fuser assembly” on page 103). 5 Remove the ECU pan (see “ECU” on page 127). 6 Disconnect the motor cable connector (callout 1) above the motor. 7 Remove the three screws (callout 2) from the motor and lift the motor out of the printer. 1 2 Figure 53. Removing the motor To reinstall Make sure that the motor is in the correct position. The connector should be above and to the back of the motor. 110 Chapter 5 - Removal and replacement ENWW