Basic troubleshooting Table 13. Basic troubleshooting # Verification steps Possible problems Solutions 1 Does the printer turn on successfully? When the product is connected to a grounded power source, the printer motor should rotate for approximately five seconds. No power (no LEDs are lit). 1. Verify that the product is plugged in. 2. Verify that the power cable is functional and that the power switch is on. 3. Verify that FU102 on the ECU is not open. 4. If all of these conditions are correct, replace the ECU. Printer motor does not rotate. 1. Verify that the print cartridge is present. (See “Print cartridge” on page 76 for more information.) 2. Verify that the printer door is closed. 3.
Verify that media is loaded in the main input tray. 4. Verify there are no paper jams. 5. Verify that the printer paper path and door sensors are functional. 6. Verify that the motor connector is seated into the ECU. 7 Verify that the motor is correctly mounted on the printer chassis. 8. If all of these conditions are correct, replace the ECU. 9. If, after replacing the ECU, the printer motor still does not rotate, replace the motor. 2 Is the product ready? The control panel should function without error light patterns. Control panel displays an error light pattern. Consult the list of control panel light patterns later in this chapter to identify and correct the error.
Control panel is not functional. 1. Verify that the control panel cable is seated in the formatter. 2. If the cable is connected correctly, replace the control panel. 3 Do engine tests and self-test pages print? Print an engine test. (See “Engine test” on page 156.)The engine test should print without paper-feed problems or print-quality problems. Note The formatter must be connected to perform an engine test. Engine test is not successful. Replace the ECU. Control panel displays an error light pattern. See “Control panel light messages” on page 142 to identify and correct the error. Media does not move smoothly through the printer paper path.
Isolate printer paper-path problems by performing a paper-path check, which is discussed later in this chapter. Poor print quality. See “Solving image-quality problems” on page 149. 140 Chapter 6 - Troubleshooting ENWW