omron — Understanding Tag Properties and Parameters

Tags and the Project Database Setting Tag Properties Understanding Tag Properties and Parameters Each tag type has the following properties: • Parameters • Alarms Properties • History Properties To configure these properties for a tag, click Properties on the Home tab of the ribbon. A Tag Properties dialog displays, similiar to the following: Tag Properties dialog for Boolean tag Use the parameters on this dialog to configure the different tag properties. Instructions for configuring each type of tag follows. String-Type Tag Parameters From the Tag Properties dialog, specify string-type parameter properties as follows: • Retentive Value checkbox:

Click (check) to save the tag value continuously in case the system unexpectedly shuts down, so that it restarts from the last saved value. • Retentive Parameters checkbox: Click (check) to save runtime changes in the tag's properties. Only certain properties can be saved; for a complete list of which can and cannot, see List of Tag Properties on page 121. Caution: Enabling either of the Retentive options for tags that frequently change values can cause heavy disk access, which slows performance. • Startup Value field: Type a tag value for the system load. The tag assumes this value if you disable the Retentive Value option. • Unit field:

Type any string (up to 9 characters) as a brief description or reference. This tag is accessible during runtime. Note: IWS will not accept writing values that fall outside the ranges defined in the Min and Max fields. In addition, IWS generates a message in the Output window to indicate that the system tried to write a value outside the defined range. Integer and Real-Type Tag Parameters Note: For descriptions of the Retentive Value , Retentive Parameters , Startup Value , and Unit parameters, see String-Type Tag Parameters above. From the Tag Properties dialog, specify integer and real-type parameter properties as follows: • Engineering Units area Page 118 InduSoft Web Studio