Communication with Other Devices X = Item has been tested Main Driver Sheet The development application automatically inserts the MAIN DRIVER SHEET into the driver folder as soon as you add the driver to your project. Note: The MAIN DRIVER SHEET is not available for all drivers. To configure the MAIN DRIVER SHEET, right-click on the icon, and select Open from the pop-up or just double-click on the icon. The MAIN DRIVER SHEET dialog displays (see the following figure). Sample MAIN DRIVER SHEET The MAIN DRIVER SHEET worksheet is divided into two areas:
• Header area (top section), contains parameters that affect the all tags configured in the Body area of this worksheet; and • Body area (bottom section), where you define the relationship between tags in the project and their field equipment address. Use the Header area parameters as follows: • Description field: Type a description of the MAIN DRIVER SHEET for documentation purposes. • Disable field: Type a tag or an expression to enable and disable the communication of each MAIN DRIVER SHEET on the fly. • Type a value (or expression result) that is greater than zero to disable the MAIN DRIVER SHEET. • Type a zero (or leave this field blank) to enable the MAIN DRIVER SHEET.
• Read Completed field: Type in a tag and the communication driver toggles the tag when it completes a read command. • Read Status field: Type in a tag, which is updated with the status of the last read command. • Write Completed field: Type in a tag and the communication driver toggles the tag when it completes a write command. • Write Status field: Type in a tag, which is updated with the status of the last write command. • Min and Max checkbox: Click (check) to specify minimum and maximum values for data from the field equipment. • Min and Max fields (become active only when you enable the Min and Max checkbox): Type a range of values, which can be converted into an engineering format.
The project uses these fields to determine a minimum/maximum range of values for data from the field equipment. The scaling is done automatically. You must configure the engineering range using the Min and Max parameters on the Tag Properties dialog. This range affects all tags in the worksheet, except Page 296 InduSoft Web Studio Driver Modem TCP/IP UDP/IP MODSL X X X ABKE X X X MODBU X X OMETH X