Communication with Other Devices available, Auto Detect 2 will use the second, Auto Detect 3 will use the third, and Auto Detect 4 will use the fourth. • Phone field: Enter a phone number that the driver will use to connect to the remote device. This field accepts tags between curly brackets. • Settings button: Click on this button to configure the modem settings. The window that displays when you click on this button depends on the operating system that you are using and on the modem type. Caution: The settings configured by clicking on this button are not saved with your project.
The information is saved on the operating system registry, and they are valid only in the computer that you are interacting with. If you install your project on another computer, you will have to reconfigure these settings. • Connection button: Click to open the Connection Control window. The default connection settings should suffice for most of the projects. However, you can take full control over the connection, and also enable incoming calls, by clicking on this button. Connection Control dialog • Dial out trigger field: When the value of the tag configured in this field changes, the driver will try to connect to the remote device.
If the connection has already been established, the command is ignored. You do not have to use this field if you are using Auto Connect. • Hang up trigger field: When the value of the tag configured in this field changes, the driver will disconnect from the remote device. If the device is disconnected the command is ignored. You do not have to use this field if you are using Disconnect call if idle for more than. • Auto Connect field: When this option is enabled, the driver will try to connect to the remote device before sending any information. If the connection fails, the next attempt will be made after the Retry Interval has expired. • Disconnect call if idle for more than field:
When this option is checked, the driver will automatically disconnect from the remote device if no communication is performed after the time you specified. • Enable incoming calls field: Check this option if you want to enable the driver to receive calls from the remote device. You can use the Hang up trigger to drop the call once it has been established. Notice that one driver can use both incoming calls and outgoing calls. • Status area • Code field: Enter with a tag that will receive one of the following codes when the driver is running: • 0 = Disconnected • 1 = Connected • 2 = Dialing • 3 = Dropping • Description field:
Enter with a tag that will receive a complete description of the current status. The description is associated with the Code field; however, it brings some additional information about the current status. • 4 = Closing Line Serial Encapsulation Tests Most of the serial drivers should work with every serial encapsulation mode. However, most of the drivers were developed before the encapsulation modes had been created. The following table lists the drivers fully tested with certain encapsulation modes; if the driver that you intend to use is not listed and you are unsure whether it will work, please contact your distributor. InduSoft Web Studio Page 295