omron — Configuring server settings for security modes

Project Security Configuring server settings for security modes If you set your project's security mode to either Distributed – Client or Domain (LDAP), then you must also configure server settings. When you click Server Settings in either the security system configuration wizard or the main Security System dialog , the appropriate Server Settings dialog will be displayed. Configuring server settings for Distributed – Client To configure the server settings: Server Settings dialog for Distributed – Client 1. In the Server IP and Server Port boxes, type the IP address of a runtime project that is set to Distributed – Server . 2.

In the Connection timeout box, type the timeout (in seconds) after which the client will attempt to reconnect to the server. (A typical connection timeout is 3 seconds.) 3. In the Synchronization Period box, type the frequency (in seconds) at which the client will synchronize its security system configuration with the server's. (A typical synchronization period is 10 seconds.) 4. In the Force Cache Reload box, type the name of a project tag (Integer or Boolean type). If the tag value is TRUE (non-zero) and the specified server has a timestamp older than the client, then the local security system will be updated with outdated server information. 5.

In the Status Tag box, type the name of a project tag (Integer type) that will receive server connection status codes during runtime: 6. Click OK . Page 324 InduSoft Web Studio Status Description 0 No cache 1 Updated cache 2 Outdated local cache 3 Outdated server cache 4 Disconnected from server