omron — Examples of Client/Server Architecture

Deploying as a Web Application Examples of Client/Server Architecture This section describes some example architectures applied for web-based solutions and provides information on how to configure the project for each architecture. This section does not describe all possible architectures, but it provides the concepts necessary to design and configure different scenarios based on the basic architectures illustrated below The Web Settings are configured by the Web tab of the Project Settings dialog. To open this dialog: on the Project tab of the ribbon, in the Web group, click Thin Client . By pressing the Advanced button, you access additional settings.

The following pictures illustrate these dialoges: The following table describes the meaning of the main Web settings illustrated in the above dialoges: The Secondary addresses can be used in the following scenarios: • When the Thin Clients can connect to either one of two redundant Servers (Web or Data); or InduSoft Web Studio Page 373 Setting Description Data Server IP Address When the Web Tunneling Gateway is disabled: The Thin Client Control (ISSymbol) uses the Data Server IP Address to connect to the IWS TCP/IP Server Task. When the Web Tunneling Gateway is enabled: The Web Tunneling Gateway uses the Data Server IP Address to connect to the IWS TCP/IP Server Task.

Secondary Data Server IP Address Same as the Data Server IP Address. However, the Secondary IP Address is used only when the connection with the Data Server IP Address fails. Web Tunneling Gateway IP Address The Thin Client Control (ISSymbol) uses the Web Tunneling Gateway IP Address to connect to the Web Tunneling Gateway. Web Tunneling Gateway Secondary IP Address Same as the Web Tunneling Gateway IP Address. However, the Web Tunneling Gateway Secondary IP Address is used only when the connection with the Web Tunneling Gateway IP Address fails.