ISPSoft User Manual 20.4 Constructing an Ether Link 20.4.1 Introduction of an Ether Link An Ether Link is a network mechanism for data exchange performed through an Ethernet connection. If there are several nodes in an Ethernet network, users can create a mechanism for data exchange in the network, and select a start mode. If the parameters which are set are downloaded to the PL Cs in the network, the systems of the PLCs perform data exchange according to the start mode selected when the PLCs run. The users do not have to write a redundant program. A PLC Link is a master/slave model.
There is only one master station in an RS-485 network, and the other stations which are slave stations passively receive reading/writing commands from the master station. Compared with a PLC Link, an Ether Link adopts a safer data request mechanism. It is the data demanding nodes in an Ethernet network that execute an Ether Link. An Ether Link is not a master/slave model. It allows a node to send reading commands which ask for data to other nodes. The nodes will send the data to the node after they receive the reading commands. Owing to the a PLC Link.
Besides, all the nodes in an Ethernet network can send reading commands through TCP/IP, and fact that a node cannot send writing commands to other nodes, the use of an Ether Link is safer than the use of the system automatically manages the transmission of packets through TCP/IP. Compared with a PLC Link, an Ether Link is more efficient. Please refer to the example below for more information. If users want to create an Ether Link shown below, they have to create a data exchange table for the two data request nodes AH-01 and AH-02. (a) AH-01 reads the data in D100~D109 in AH-02, and stores the data in D0~D9 in itself.
(b) AH-02 reads the data in D200~D219 in AH-01, and stores the data in D110~D129 in itself. 20-58