Delta ISPSoft — 20.4.2 Open Ether Link Configuration

Chapter 20 Network Configuration and Data Exchange An Ether Link is based on a network. If a node is connected to several networks, users can set several groups of parameters related to Ether Links for the networks. As a result, there may be several groups of parameters related to Ether Links in a PLC. Owing to the fact that an Ether Link is not a master/slave model, each node in a network can be a data demanding node and a data supply node at the same time. In the first piece of data in data in the table above, AH-01 is a data providing node, and AH-02 is a data requiring node. the table above, AH-01 is a data requiring node, and AH-02 is a data providing node.

In the second piece of 20.4.2 Open Ether Link Configuration To construct an Ether Link, they have to make sure that a network is set correctly. There are three ways to open the Ether Link Configuration window.  Method 1 After the users select a network, they have to click Construct Ether Link on the Tools menu, or on the toolbar.  Method 2 Double-click a network. 20-59