Delta ISPSoft — 23.1.8 Control Mode - 2-axis Arc Interpolation Motion

Chapter 23 Wizard Tool 23.1.8 Control Mode - 2-axis Arc Interpolation Motion Description regarding 2-axis arc interpolation mode performs the motion on XY plane. Two data are used for this mode.  No. : The number is generated by the system, the 2-axis mode occupies two data. The second data No. will add a T in front of the number. Under 2-axis mode, the maximum No. is 100 and T100, a total of 100 set.  Control Mode: A motion type. Choose 2-axis arc interpolation motion .  Coord: The X or Y coordinates in the simulation graph.  Axis No.: An axis controlled by the data.  ABS/REL mode: Relative Mode increases or decreases based on the current coordinates.

Absolute Mode increases or decreases based on the absolute coordinates as target position. Relative mode (Symbol/Address) increases or decreases based on the current coordinate address, symbol or address are allowed. Absolute mode (Symbol/Address) increases or decreases based on the absolute coordinates as target position, symbol or address are allowed.  Target position: Target coordinate. For ABS/REL mode , the options include symbol/address.  Tangential speed (Hz): Movement in a circular path in three dimensions and the magnitude of that vector is the tangential speed.  Center shift value:

The distance from the center of the line between the arc target point and start point to the center of a circle, such as S in the following figures. From point A to point B, a clockwise rotation will generate an arc less than 180 ° if S>0 and an arc more than 180 ° if S 23-13