JumpSurge2000 Quick Guide V2

Hotline Email Website Facebook Twitter (+1)833-629-4832 support@topdon.com www.topdon.com @TopdonOfficial @TopdonOfficial JUMP STARTER USER MANUAL FOR 12 VOLT LEAD-ACID BATTERIES

Page 1

To be environmentally friendly and consider other factors, our paper manuals are only in English, German and Japanese. For other languages, please visit our official website https://www.topdon.com/, go to the corresponding product page and click "DOWNLOADS" to download the online user manuals, or scan the QR code to visit our website and obtain online user manuals. EN (JUMPSURGE 1200) (JUMPSURGE 2000) To ensure your safety, please read carefully and understand thoroughly all safety instructions before using this product. Go to www.topdon.com for more information.

Page 2

Solid green The Jump Starter is ready for use. Type-C Input (5V/3A 9V/2A) Jump Start Socket Solid red Reverse polarity of battery clamps is detected. DC Output (Max 16.8V/10A) Power Button Flash green The battery level of the vehicle is too low. Press the "BOOST" Button and wait until the Safety Indicator becomes solid green. Then start your vehicle within 30 seconds. Battery Level Indicator The indicator doesn't light up The battery of the vehicle may be totally dead. Make sure that you have correctly connected the clamps to the vehicle battery. Then press the "BOOST" Button and wait until the Safety Indicator becomes solid green. And then start your vehicle within 30 seconds.

USB Output (5V/2A) USB Output (5/9/12V Quick Charge 3.0) LED Light Alternately Flash Red and Green You have tried 4 jump starts within 10 minutes. Please disconnect the clamps and reconnect to try again. Positive Clamp (Red) BOOST Button Safety Indicator Negative Clamp (Black) EN 1 2

Page 3

1. Press the Power Button once to turn on the jump starter. IMPORTANT: Make sure you have turned off all of the power loads of the vehicle, including headlights, radio, air conditioner, etc., before attempting to jump start the vehicle. 2. Press and hold the Power Button for 3 seconds to turn on the LED Light. Then press the Power Button once separately to toggle between Flashlight, Strobe, SOS and OFF in turn. Step1 Plug the blue end of jumper cable into the Jump Start Socket. The jump starter comes partially charged and needs to be fully charged prior to use. Please charge it through the Type-C Input port once you receive it. NOTE:

Please jump start vehicles only when the battery level of the jump starter is more than 50%. (RED) (Black) EN (Step2) 3 4

Page 4