Top Cover Assembly Figure 6-187 Top Cover Assembly 1 Remove the Stapler Assembly (see figure 6-180 on page 477). 2 Open the Top Cover Assembly, and remove the Back Plate (see figure 6-182 on page 479). 3 Unplug the ground and signal cables from the right side of the Stapler Controller board, being careful to keep them in the cable holder. See callout 1 and 3 on figure 6-185. 4 On each side of the assembly, pull the hinge to release the 2 posts from the retaining notches (see figure 6-187). To Reinstall: CAUTION Keep the Top Cover Assembly open while reconnecting the cables. Cable damage could occur the next time the cover is opened if the cables are reinstalled too tightly.
484 Chapter 6 Removal and Replacement C4265-90907