Stapler Bed Assembly Figure 6-188 Stapler Bed Assembly 1 Remove the Stapler Assembly (see figure 6-180 on page 477). 2 Remove the Back Plate (see figure 6-182 on page 479). 3 Remove the Stapler Unit Controller PCA (see figure 6-188 on page 485, callout 1). 4 Remove the Top Cover Assembly (see figure 6-187 on page 484). 5 Remove the wire frame by pushing both arms of the wire frame toward the center to clear the retaining notches and lift. 6 Release the brushes bar from the retaining notches and lifting upwards.
7 Insert a flat-blade screwdriver into the top of the Stapler Bed Assembly and push gently to release the latches in the front of the stapler bed (see figure 6-188 on page 485, callout 2). 8 Remove 3 Torx screws that join the stapler bed with the rest of the unit (see figure 6-188 on page 485, callout 3). 9 To remove the Stapler Bed Assembly, lift the edge of the assembly where the stapler unit resides, then gently lift the entire Stapler Assembly. C4265-90907 Stapler Assembly Removal and Replacement 485