L-6534VW Operation Guide Basic Operations U Enter the Substrate Width , Substrate Thickness , and Paper Core Thickness , with the key pad. c Important: Make sure the paper core thickness is set correctly when replacing the substrate (within a margin of error of ±0.5 mm). The roll end position is set automatically based on the entered paper core thickness, and an ultrasonic sensor detects the position to stop printing while some substrate still remains. If the paper core thickness is not set correctly, the trailing edge of the substrate may pass through the nip rollers A without stopping at the roll end position and then stop with a tension error.
You need to reload after removing any loaded substrate and this could take a long time to restore. V Set the Unwinding direction . c Important: Set the unwinding direction correctly. If this is not set correctly, the substrate may become loose and a tension error may occur. W Press Continue . 114 Substrate Type Substrate surface (printable surface) Liner Film Single-ply film -