L-6534VW Operation Guide Basic Operations X When feeding the splice, press Start . If you do not need to feed the splice such as when not needing to replace the substrate on the rewinder side, select Do not feed the joint . The spliced section of the substrate is fed to the rewinder axis. (Approx. 6.6 m) c Important: When feeding a splice, replace the rewinder side with a new paper core. When feeding a splice, change to the tension setting for feeding splices. Since the tension setting for rewinder changes when you do not replace the paper core, a rotation speed error for the drum may occur if you continue printing. Note:
When you feed the splice, the standard value for Tension settings is calculated automatically based on the value set in step 1 on the substrate replacement screen. When changing the settings, change the value while referring to the standard value displayed. Subsequently, replace the substrate on the rewinder side. Replacing the Rewinder Side Substrate Below is the procedure to replace the substrate on the rewinder side. 115 Operation place Contents Control panel If the Feed Ready switch lamp on the press is on, press the Feed Ready switch to release the tension from the substrate. Press Cut the substrate at the front of the rewinder axis.