L-6534VW Operation Guide Various Print Settings Move the press switch from Standby to Ready, and start printing. Positioning eye marks for additional printing For additional printing, eye marks need to be printed on the substrate in advance. Eye mark size/shape/color Create the eye marks you want to position as follows. Eye mark positioning area Position the eye marks on the right edge of the label design within the gray area shown below. It can be positioned on either the front or rear surface of the substrate. 166 Item Size Size Vertical printing direction: Between 5 and 10 mm Printing width direction:
5 mm or more Shape Square or rectangular Color Black, White The brightness of the mark must be sufficiently different from the base color of the substrate and the liner color for clear film See the following for more information on eye marks. U “Eye mark specifications” on page 68 Item Size a (print length) 30 to 1,000 mm (1.181 to 39.370 inch) b (position of detectable eye marks) 80.0 to 340.4 mm (3.150 to 13.400 inch) Differs depending on the width of the substrate loaded in the press.