L-6534VW Operation Guide Various Print Settings Note: For the distance from the top edge of the substrate to the top edge of the eye mark, 3 mm or more is recommended. When the distance is less than 3 mm, fine-tune to align the sensor light with the center of the eye mark is required. Necessary leading margin for underlying substrate For additional printing, you need to leave a leading margin for the underlying substrate. Necessary margin for the reverse feeding. a. Substrate feed direction b. Necessary leading margin = Necessary margin for the reverse feeding Prepare an underlying substrate having a leading margin referring to the table below.
The necessary leading margin for the underlying substrate varies depending on the print speed to be set in Preset for Printing. * When the tension value for either one of unwinding or rewinding is 10 N or less 167 Print Speed With normal tension With low tension* 50 m/min (Productivity) 27 m or more 33 m or more 30 m/min (Standard) 25 m or more 27 m or more 15 m/min (High density) 24 m or more 24 m or more 7.6 m/min (Reverse White) 23 m or more 24 m or more