EPSON — Ionizer/Foreign Substance Detection Roller

L-6534VW Operation Guide Maintenance B Clean the foreign substance detection roller. Dampen the polyester/nylon knit woven fabric with the alcohol for cleaning the rollers, and insert your hand from the top of the ionizer, wipe off any paper powder, dust, glue, and so on. C Check that there are no tools or jigs left inside the press. c Important: Do not leave any foreign substances inside the press. Print quality may decline, or the head could break down. You need to replace the head if it breaks down. D Remove slack from the substrate. E Return the three nip levers, and then set nip rollers A and B, and the foreign substance detection roller.

If you are going to clean the drum next, go to the appropriate item without returning the nip levers. U “Drum” on page 299 F Close the top front cover on the press. G Add a check mark to the item you have inspected, and then go to the next item for inspection. When you have finished the inspection, press Finished . This completes this section. Ionizer/Foreign Substance Detection Roller This section explains how to clean the foreign substance detection roller after cleaning the ionizer. If the ionizer is soiled or in an abnormal condition, static electricity cannot be absorbed which could have an adverse effect on the printing results.

If you are performing this procedure after cleaning the paper width sensor/eye mark sensor, go to step 2. 286