EPSON — Solutions After Stopping Due to an Error

L-6534VW Operation Guide Troubleshooting c Important: If you cannot remove the foreign substance safely, contact service support. Note: If printing stops frequently due to foreign substance detection, even though no foreign substances are present, you may be able to improve the situation by setting Foreign Substance Detection Sensitivity in Print Info. to Medium or Low . H Wind up the substrate to remove any slack on the unwinder side. c Important: If you wind substrate that is loose on the rewinder side, a drum rotation speed error may occur. If an error occurs, replace the paper core on the rewinder side with a new one. I Lock nip rollers A and B. J Close the top front cover on the press.

K Press Finished to exit Feed section mode. L If the substrate is curled at the edges and deformed, press the Feed switch on the press to feed the position of the problem to the rewinder side workbench. This completes this section. 385 Point of Occurrence Type of Foreign Substance Solution Route channel from the eye mark sensor to the foreign substance detection roller Substrate deformed (wrinkles or creases), scraps of paper, glue, and so on ❏ Check the substrate between the eye mark sensor and the foreign substance detection roller for foreign substances, and remove any that you find. ❏ Clean the foreign substance detection roller. U “Foreign substance detection roller” on page 285