L-6534VW Operation Guide Troubleshooting Adjusting Using Head Stitch The method for adjusting head stitching differs depending on the Nozzle Overlap setting in the preset for printing. U “When Nozzle Overlap is set to Standard ” on page 387 U “When Nozzle Overlap is set to Customized ” on page 392 If streaks are not reduced by setting Nozzle Overlap to Standard and making adjustments, try setting to Customized and then adjusting. To adjust the image quality to your liking, you can try setting Customized first. Note: Since the nozzle control method used at the head stitches differs when Nozzle Overlap is set to Standard and when it is set to Customized, the streaks also look different.
When it is set to Customized, the streaks appear thinner and clearer. The width of the streaks is approximately 3 mm for Standard (a) (approximately 1 mm for Y), and approximately 0.1 mm for Customized (b). When Nozzle Overlap is set to Standard 387