EPSON — When Nozzle Overlap is set to Customized

L-6534VW Operation Guide Troubleshooting J Repeat Density adjustments and test printing until the streaks are no longer noticeable. This completes this section. Note: ❏ If you replace the substrate after the adjustments are complete, adjust the Nozzle Overlap and Density in that order. If you change the image, you only need to adjust the Density . ❏ Even if you adjust the Nozzle Overlap and Density, some types of streaks may remain. ❏ When performing white printing onto a substrate with low wettability, white streaks may remain even after adjusting the Nozzle Overlap and Density.

In this situation, you may be able to improve the condition of the streaks by setting the corona output level set to 500 W and performing corona treatment. 394