L-6534VW Operation Guide FAQ Note: ❏ If you print a job with Print Preset of Paper #1 and Paper #1, High density, the print result with Paper #1, High density will have deeper color overall. This also applies for Film #1 and Film #1, High density. ❏ When you want to increase the quality of ink distribution, but you do not want to make colors deeper, print a job rasterized using the respective ICC profiles for Paper #1 and Paper #1, High density. This can reduce the color difference between Paper #1 and Paper #1, High density. This also applies for Film #1 and Film #1, High density.
Corona Treatment When Corona Treatment is set, press the UP / DOWN switches to adjust the output of the corona treater within a range of 100 to 2,000 W while making test prints and checking the print outs. When using the reverse feeding function to perform reverse feed of the substrate after pausing, depending on the number of times printing is paused, there may be differences in the quality of ink distribution due to the number of times corona treatment is performed for the same section. Make the following settings in the preset, and check the print results.
410 Substrate Recommended print mode Paper (semi-gloss) Uncoated paper Paper (cast) Paper #1 In Paper #1, High density, the amount of dots and ink is increased compared to Paper #1. Select this in the following cases. ❏ You want to increase the quality of ink distribution on the filled-in areas ❏ You want to make black or other colors deeper ❏ You want to increase the color gamut Foil paper White film Clear film Metallized film Film #1 Select Film #2 if blurred characters, bar codes, or lines are noticeable on the printout when Film #1 is used. In Film #1, High density, the amount of dots and ink is increased compared to Film #1. Select this in the following cases.
❏ You want to increase the quality of ink distribution on the filled-in areas ❏ You want to make black or other colors deeper ❏ You want to increase the color gamut Item Set value Pause (After Print) Apply Stop Position After Print Rewinder Side Workbench Reverse Feeding Apply Eye Mark for Reverse Feeding Do Not Use