EPSON — Print quality declines due to ink distribution

L-6534VW Operation Guide FAQ Substrate becomes discolored A. For thermal paper, print without using the additional UV lamp curing unit. If ink does not cure when not using the additional UV lamp curing unit, change the substrate, or try laminating. How can I reduce waste? A. Except when replacing the substrate, try not to release the tension for the substrate. When restoring tension to the substrate after releasing the tension, you need to feed approximately 8 m of substrate until the substrate feed speed stabilizes. Check the following points.

❏ Do not press the Feed Ready switch ❏ When replacing the substrate, align the paper edge sensor with the width of the substrate ❏ When replacing the substrate, set the substrate type so that it matches the substrate ❏ Do not touch the tension roller ❏ When replacing the substrate, pump air into the unwinder axis, and secure the substrate ❏ When cutting the substrate on the rewinder side, do not pull too forcefully on the substrate ❏ When replacing the substrate, connect the centers of the substrates together. If the centers of the substrates misalign, the press needs to feed more substrate to ensure stability. Print quality declines due to ink distribution A.

You can improve the quality of ink distribution using the print mode setting items for the preset and by adjusting corona treatment. The print mode and the corona treatment settings affect how the ink is spread. Print Mode Select a print mode that matches the substrate. When using substrate that has already been checked, copy and use the preset that matches the recommended print mode. When using new substrate, make a test print and check the print outs while referring to the following table to select the appropriate print mode. 409