EPSON — Printing may stop automatically

L-6534VW Operation Guide FAQ Printing may stop automatically A.1 If the temperature of the printing area exceeds 48 degrees, printing stops to cool down. When the temperature of the printing area (the drum) increases, the press may malfunction, print quality may decline, and the substrate may deteriorate; to prevent this, printing stops automatically to allow it to cool down and the substrate is reversely fed to the position before it was paused, and then printing resumes. Also, 90 seconds is added to the reverse feeding time for the substrate as a standard cool-down period.

During print jobs that use a lot of ink (especially Wh ink) on thin film substrate, the temperature of the printing area increases easily. Take the following measures to prevent the temperature from increasing. ❏ Make the Print Speed setting slower in Preset for Printing than the current setting. ❏ Use analog varnish ink instead of Dv ink (Dv-ink models only) ❏ Reduce the number of collated copies and number of copies to reduce the printing time ❏ Reduce the environmental temperature ❏ Reduce the width of the substrate A.2 Printing may stop automatically in the following cases as the print quality may decline. Wait until printing automatically resumes.

❏ When periodic auto head maintenance is being performed ❏ When the printing area (the drum) reaches the maximum temperature ❏ When the head reaches the maximum or minimum temperature ❏ When ink is running low ❏ When print data cannot be processed in time Pausing and resuming printing may cause gaps in the print results that require readjustment of the die cutting position during post-processing. You can improve this issue by making the following settings on the For Reverse Feeding tab in Preset Management . See the following for more information on creating presets for reverse feeding.

U “Creating Preset for Reverse Feeding” on page 94 408 Item Set value Reverse Feeding Apply Eye Mark for Reverse Feeding Use