L-6534VW Operation Guide FAQ Concerned about small text and distortion of thin lines A.1 Verify the rasterizing data after RIP processing, correct the print data or change the substrate. Confirm the data after RIP processing, and check whether or not text is illegible. If text is illegible in the data, use an application such as Adobe Illustrator to correct any thick lines. If the text is legible, change the substrate, and then re-print. A.2 Make settings related to sharpening in presets for printing. Set Sharpen (Color Printing) or Sharpen (White Printing) to Enable in the Preset for Printing that you are using. Sharpen (Color Printing) makes colors (CMYK) clearer.
Sharpen (White Printing) makes the outlines for white text and images clearer. Adjust Sharpen Threshold and Sharpen Strength while checking the print result. Note: ❏ When Sharpen Strength is set to Strong , streaks may appear at the borders between colors. ❏ When Sharpen (Color Printing) is set to Enable , white streaks may appear in the print results. Stripes may appear in the print outs when using film substrate A. If printing is paused for an extended period, the wettability of the point where the substrate is secured by the nip roller changes, and stripes may appear on the substrate.
When the press is set to perform reverse feed of the substrate and when pausing for a long time between the current print job and the next print job The solution differs depending on whether you are cutting the substrate or inserting a margin when printing is complete. When cutting the substrate when printing is complete, the substrate is not reversely fed before starting the next job; therefore printing is not performed at that point on the substrate where the wettability has changed. If you have not inserted a margin between the next print job in the preset for printing, set Stop Position After Print to Unwinder Side Workbench .
When inserting a margin between the current job and the next job, set Lead In to 5 m or more to prevent printing on the area where the wettability of the substrate has changed. When performing base printing and additional printing with the press Note the following points, and then perform base printing. ❏ Reduce the size of the job so that the printing time is less than 30 minutes ❏ Prevent auto head maintenance from starting during printing U “Can I stop the press from entering head maintenance mode during printing?” on page 405 Also, set all three items in Auto Head Maintenance from Print Operation Settings to Do Not Apply . ❏ Do not pause during printing 407