L-6534VW Operation Guide FAQ Banding occurs when using Wh ink or Dv ink A.1 If streaks are at regular intervals in the feeding direction, try performing Head Stitch Density Adjustment. You may be able to reduce banding by adjusting the density with (Subs) Head Stitch Density Adjustment in the preset for printing. U “Streaks at Regular Intervals in the Print Result” on page 386 A.2 Try performing corona treatment. You may be able to reduce banding on the substrate by performing corona treatment. Set Corona Treatment in the preset for printing to Apply , and then check the print results. Blurred characters or bar codes are noticeable A.
Print with Wh ink on and around the area where blurring or bleeding is noticeable. To print with Wh ink on the blurred or bled area, follow the steps below to modify the print data. 417 Note: Example) Outputting the eye mark alignment temperature correction factor when the drum temperature is 42˚C and the amount of shift in the print position is -0.3 mm Correction value = amount of shift in the print position / (checked drum temperature -25), therefore: -0.3/(42-25)=-0.01764... The calculated value is -0.01764..., therefore select the closest correction amount which is "-0.02" from the table in step 5.
The eye mark alignment temperature correction factor that corresponds to the correction value -0.02 is "-2". Therefore, enter "-2" in Align eye mark temp correction factor.