INTRODUCTION - Rivet Removal and Installation IN-15 RIVET REMOVAL 1.
SELECTION OF CUTTING TOOL LX470 Mandrel Flange øX mm Rivet Size RIVET REMOVAL AND INSTALLATION PARTS NAME AND VARIETY OF RIVET Aluminum-Rivet Steel-Rivet Waterproof-Rivet T-Rivet External Appearance Before installation After installation Outer Inner Before installation After installation Outer Inner Before installation After installation Waterproof Seal Outer Inner Before installation After installation Mandrel Outer Inner Charac- teristics Small nonwaterproof rivet No magnetic adherence Small nonwaterproof rivet Magnetic adherence Small waterproof rivet Waterproof seal Large waterproof rivet Mandrel sticks out after installation Cutting tool Note Aluminum-Rivet Steel-Rivet T-Rivet with ø6.4 mm Drill blade Rivet size Blade size ø4 mm ø4 mm ø4.8 mm ø5 mm ø6.4 mm ø6.5 mm Cutting can be done with drill blade or rivet cutter for an aluminum-rivet with ø4.8 mm.
When a rivet cutter is used for an aluminum-rivet (except ø4.8 mm), a steel-rivet, or a T-rivet with ø6.4 mm, it is possible that the drill will spin abnormally damaging the rivet hole and breaking the rivet cutter. Waterproof special-Rivet with ø4.0 mm Drill blade with ø4.0 mm Aluminum-Rivet with ø4.8 mm Waterproof-Rivet with ø4.8 mm or ø6.0 mm Rivet Cutter (P/N 09060-60350) When a ordinary cutter is used for a waterproof-rivet with ø4.8 mm or ø6.0 mm, the rivet can not be cut as it spins with the cutter. Rivet size Blade size ø4 mm ø4 mm ø4.8 mm ø5 mm ø6.4 mm ø6.5 mm