HP — Input/Output

PowerSave This feature conserves power after the printer has been idle for an adjustable length of time. Set the time length in the Configure Device menu, under System Setup. When the printer is in PowerSave mode, the control panel backlight is turned off, but the printer retains all printer settings, downloadable fonts, and macros. The default setting is POWERSAVE= ON , with a 30-minute idle time. You can turn PowerSave off in the Configure Device menu, under Resets. The printer exits PowerSave mode and enters the warm-up cycle when any of the following occurs: G A print job, valid data, or a PML or PJL command is received at the parallel port, serial port, FIR port, or EIO card.

G A control panel button is pressed. G The top cover is opened. G A paper tray is opened. G The engine test button is pressed. Note Printer error messages override the PowerSave message. The printer enters PowerSave mode at the appropriate time, but the error message continues to appear. Input/Output Parallel interface The formatter receives incoming data through its bidirectional interface (IEEE-1284). The I/O provides high-speed and two-way communication between the printer and the host, allowing the user to change printer settings and monitor printer status from the host computer. The user can configure the HIGH SPEED item in the control panel menu.

(This item is found in the CONFIGURE DEVICE menu, under I/O menu, and PARALLEL INPUT .) The default setting, YES , allows the I/O to run at the higher speeds supported by most newer computers. When set to NO , the parallel interface runs at the slower mode that is compatible with older computers. The user can also configure the ADVANCED FUNCTIONS item. The default setting, ON, allows for two-way parallel communications. The OFF mode disables the advanced functionality. The I/O is compatible with the bidirectional parallel interface standard.

Expanded I/O The optional HP Fast InfraRed receiver enables wireless printing from any iRDA-compliant portable device (such as a laptop computer) to the printer. The printing connection is maintained by positioning the sending infrared port within operating range. The connection can be blocked by objects such as a hand or paper, or by direct sunlight or any bright light shining into either infrared port. Flash Optional flash is available in 4 MB flash memory DIMMs for storing forms, fonts, and signatures. Hard-disk accessory The optional hard-disk accessory can be mounted in one of the EIO slots on the rear of the formatter.

The optional EIO-based hard disk is used for creating multiple original prints (mopies) and storing forms, fonts, and signatures. CPU The HP LaserJet 4600 series printer formatter incorporates a 400 MHz RISC processor. C9660-90901 Chapter 5 Theory of operation 101