Printer memory If the printer encounters difficulty managing available memory, a clearable warning message will appear on the control panel. Some printer messages are affected by the auto-continue and clearable warning settings from the Configure Device menu, under System Setup. If CLEARABLE WARNING = JOB is set on the control panel, warning messages appear on the control panel until the end of the job from which they were generated. If CLEARABLE WARNING = ON is set, warning messages appear on the control panel until is pressed. If an error occurs that prevents printing and AUTO CONTINUE = OFF is set, the message appears until is pressed.
Read-only memory Besides storing microprocessor control programs, the read-only memory (ROM) stores dot patterns of internal character sets (fonts). Random-access memory The random-access memory (RAM) contains the page, I/O buffers, and the font storage area. It stores printing and font information received from the host system, and can also serve to temporarily store a full page of print-image data before the data is sent to the print engine. Memory capacity can be increased by adding DIMMs to the formatter. Note that adding memory (DIMMs) might also increase the print speed for complex graphics. DIMM slots The DIMM slots can be used to add memory, fonts, or firmware upgrades.
Firmware DIMM To upgrade printer firmware, insert a new firmware DIMM in the slot marked J1. See page 85 for more information. Nonvolatile memory The printer uses nonvolatile memory (NVRAM) to store I/O and information about the print environment’s configuration. The contents of NVRAM are retained when the printer is turned off or disconnected. PJL overview Printer job language (PJL) is an integral part of configuration, in addition to the standard printer command language (PCL). With standard cabling, PJL allows the printer to perform functions such as: G Two-way communication with the host computer through a bidirectional parallel connection.
The printer can tell the host about such things as the control panel settings, and it allows the control panel settings to be changed from the host. G Dynamic I/O switching allows the printer to be configured with a host on each I/O. The printer can receive data from more than one I/O simultaneously, until the I/O buffer is full. This can occur even when the printer is offline. G Context-sensitive switching allows the printer to automatically recognize the personality (PS or PCL) of each job and configure itself to serve that personality. G Isolation of print environment settings from one print job to the next.
For example, if a print job is sent to the printer in landscape mode, the subsequent print jobs print in landscape only if they are formatted for landscape printing. 102 Engine control system C9660-90901