Image stabilization control As the print cartridge ages, the toner and the photosensitive drum begin to deteriorate, which can cause fluctuations in image density. The printer accounts for this with image stabilization control. There are two kinds of image stabilization control: G image density calibration control G image halftone calibration control Each control operates as necessary. Image density calibration control (DMAX) This control stabilizes image density by calibrating the values of the developing bias whenever one of the following events occurs:
G when the printer is turned on G when a print cartridge is replaced G after a set number of pages have printed G when the formatter sends an operation command Image density calibration consists of three steps: 1 The DC controller forms density patterns for each color on the ETB using varying levels of developing bias. 2 The color registration detection unit measures the image density of the density patterns formed on the ETB. 3 The DC controller uses the density measurements to adjust the developing bias to obtain proper image density.
Image halftone calibration control (DHALF) This control measures halftone density output from the formatter and returns the measurements to the formatter so it can perform halftone calibration. Image density calibration must always be performed prior to image halftone calibration. Image halftone calibration control consists of three steps: 1 Using the optimum developing bias determined during image density calibration, the DC controller forms density patterns on the photosensitive drum in each color cartridge. 2 These density patterns are transferred to the ETB, and the color registration detection unit measures the image density of these patterns. Image data is returned to the formatter.
3 The formatter uses the image data to perform a halftone calibration in order to obtain an ideal halftone image. C9660-90901 Chapter 5 Theory of operation 123