HP — DC controller shield

Internal components DC controller shield To access and service many of the internal components, you first need to remove the DC controller shield on the left side of the printer. To remove the DC controller shield 1 Remove the print cartridges and the ETB. 2 Remove the rear cover. See page 144. 3 Remove the top cover. See page 145. 4 Remove the rear top cover. See page 146. 5 Remove the left cover. See page 148. 6 Remove the 9 screws shown in callout 1. 7 A possible tenth screw might be located on the rear of the printer at the bottom of the DC controller shield (callout 2). If a screw is present, remove it. 8 Remove the DC controller shield.

1 1 2 2 Figure 6-17 Removing and replacing the DC controller shield C9660-90901 Chapter 6 Removal and replacement 155