HP — Paper pickup unit

Internal components (front) Paper pickup unit 1 Remove the DC controller shield. See page 155. 2 Move the ETB latch receptacles to the UP position. Use a screwdriver to rotate them because they are stiff. 3 Remove the two screws shown in callout 1. 4 Disconnect the connector (J1020, shown in callout 2) from the DC controller PCB. 5 Lift the paper pickup unit, and pull it forward. Guide the connector through the trough shown in callout 3. 1 Figure 6-18 Removing and replacing the paper pickup unit (1 of 2) 2 3 Figure 6-19 Removing and replacing the paper pickup unit (2 of 2) 156 Internal components (front) C9660-90901