Alphabetical printer messages Note Many of the procedures in this section instruct you to replace the DC controller PCB, the ETB, the formatter, the drum drive motors, the drum drive gears, or a laser/scanner unit. After replacing one of these items, you must access the Print Quality menu and select CALIBRATE NOW to ensure proper print quality after the repair. See “Calibrate Now” on page 294 for instructions on calibrating the printer. When the ETB or the fuser are replaced before their normal end of life, access the resets menu and reset the counter to zero. See page 81 and page 83 for instructions.
Table 7-2 Alphabetical printer messages 212 Printer error troubleshooting C9660-90901 Message Description Action Access denied menus locked An attempt has been made to modify a menu item while the control panel security mechanism is enabled by the printer administrator. The message will disappear shortly, and the printer will return to Ready state. Contact the printer administrator to change settings. CHOSEN PERSONALITY NOT AVAILABLE For help press alternates with CHOSEN PERSONALITY NOT AVAILABLE To continue press PJL encountered a request for a personality that did not exist in the printer. The job is aborted and no pages will be printed. 1 Press for detailed information.
2 Press and to step through the instructions. CLOSE FRONT COVERS For help press The covers need to be closed. 1 Press for more information. 2 Close front covers. Note: This message might also appear if the fuser is missing or incorrectly installed. Ensure that the fuser is correctly installed. CPR SENSOR OUT OF RANGE The CPR Sensor is not behaving properly. 1 Force a calibration by selecting Calibrate Now from the Print Quality menu. See “Calibrate Now” on page 294. 2 If the message persists, verify the cables are seated properly and the connector J1024 is making good contact with the DC controller. 3 Replace the color registration detection unit.
4 If the message still persists, replace the DC controller PCB. Calibrate the printer after replacing the DC controller. DATA RECEIVED To print last page press The printer received data and is waiting for a form feed. When the printer receives another file, the message should disappear. Press to continue.